ATI Mach
The ATi Mach line was a series of 2D graphics accelerators for personal computers developed by ATI Technologies. It became an extension (and eventual successor) to the ATI Wonder series of cards. The first chip in the series was the ATi Mach8. It was essentially a clone of the IBM 8514/A with a few notable extensions such as Crystal fonts. Being one of the first graphics accelerator chips on the market, the Mach8 did not have an integrated VGA core. In order to use the first Mach8 coprocessor cards, a separate VGA card was required. This made ownership considerably expensive. A temporary solution was presented with the ATi Graphics Ultra/Vantage cards, which combined an ATi 8514 Ultra and VGA Wonder+ into a single card (though using discrete ICs). The Mach32 chip was the follow-up to the Mach8, which finally featured an integrated VGA core, true colour support and a 64-bit datapath to internal memory.
Models
Mach 8
Released: 1991
- IBM 8514/A clone
- Support for up to 8-bit colour modes
- Optional VGAWonder 2 (28800) graphics core (with dedicated 256–512 kb DRAM)
- 512 KB or 1 MB available with either DRAM or VRAM
- Port: ISA, MCA
The Mach 8 chip was used on the following ATI products:
- 8514 Ultra (VRAM, coprocessor only)
- 8514 Vantage (DRAM, coprocessor only)
- Graphics Vantage (DRAM)
- Graphics Ultra (VRAM)
- VGAWonder GT (Repackaged Graphics Ultra, 1 MB RAM standard)
Mach 32
Released: 1992
The Mach 32 chip was used on the following ATI products:
- Graphics Wonder (DRAM)
- Graphics Ultra + (DRAM, fast RAMDAC)
- Graphics Ultra CLX (DRAM, cost-reduced OEM version)
- Graphics Ultra Pro (VRAM)
- Graphics Ultra XLR (VRAM, cost-reduced OEM version)
Mach 64
Released: 1994
- 64-bit GUI accelerator with basic DOS support
- Limited VESA VBE support
- Video memory: 1, 2, 4 or 8 MiB DRAM, VRAM, or SGRAM
- Memory interface: 64-bit
- Port: ISA, VLB, PCI
- Variants:
-
- "Mach64 CX/210888" - Original chipset, uncommon (up to 2 MB DRAM, or 4 MB VRAM)
- "Mach64 GX/210888GX" - Enhanced video playback capabilities
- "Mach64 ET/210888ET" - Embedded???
- "Mach64 CT/264CT - Cost-reduced Mach64 with integrated RAMDAC and clock chip (up to 2 MB DRAM)
- "Mach64 VT/264VT - AMC connector (Support for TV-tuner)
- "Mach64 GT/264GT 3D Rage" - 3D capabilities
- "Mach64 GT-B/264GT-B 3D Rage II - SDRAM & SGRAM support(up to 8 MB)
- "Mach64 LT/264LT" - Low-power mobile version of Mach64 GT
The Mach 64 chip was used on the following ATI products:
Mach64 GX Family:
- Graphics Xpression (1 or 2 MB DRAM)
- Graphics Pro Turbo (2 or 4 MB VRAM)
- WinTurbo (1 or 2 MB VRAM, non-upgradable)
- Graphics Pro Turbo 1600 (fast RAMDAC,PCI-only)
- XCLAIM GA (Macintosh)
Mach64 CT Family:
- WinBoost (1 MB DRAM, upgradable to 2mb)
- WinCharger (2 MB DRAM)
Mach64 VT Family:
- Video Charger
- Video Xpression (Mach64 VT2)
- Video Xpression+ (Mach64 VT4)
Mach64 GT Family:
- 3D Xpression (2 MB EDO DRAM))
Mach64 GT-B Family:
- 3D Charger (2 MB EDO DRAM)
- 3D XPRESSION+ (2 or 4 MB SDRAM)
- 3D XPRESSION+ PC2TV (TV-out)
- 3D Pro Turbo (2, 4, 6 or 8 MB SGRAM)
- 3D Pro Turbo+ PC2TV (TV-out)
- Xclaim VR - early versions (Macintosh, 2, 4 or 8 MB SGRAM, Video-In Video-Out)
- Xclaim 3D - early versions (Macintosh, 4 or 8 MB SGRAM)
- All-In-Wonder (SDRAM, TV Tuner)
Important Note: The 3D Rage and 3D Rage II chips were also known as Mach64 GT and Mach64 GT-B respectively. The Mach64 moniker was eliminated with introduction of the 3D Rage Pro.
External links
|
|
|
|
Consumer graphics processing units
|
|
|
|
|
|
|
|
|
|
Other products and technologies
|
|
|
|
|
|
|
1 Upcoming product 2 Discontinued product
|
|